Table of Contents
Installing a new garage door in Seattle is not an easy task for a simple homeowner.
With that, a garage door installation in Seattle must be called for.
However, should you have the right tools and expertise for the job, you can also do the task on your own.
This article provides information on how to install a new garage door.
-
Free the door of its tension.
For the first step, simply release the tension that is carried by the garage door.
You should be cautious in doing this, as the springs of the garage door are under a huge amount of weight as well as tension.
Handle it wrong and it may cause injuries as well as damages.
Given that, before you work on the installation, you should release the tension first from the torsion springs.
-
Deactivate the opener.
Installing a new garage door in Seattle requires that you unplug the opener after you have secured the release of the tension from the springs.
To unplug it safely, all you need to do is pull the red emergency cord.
You can then move the arm of the trolley vertically so that you can raise or lower the door using your bare hands.
Once done, start with the removal of the sectional door panels.
-
Position the panels.
Make sure that the steps above have been completed before moving on to the proper installation of the garage door.
If the garage door has two cars, then you should place a reinforcing bar at the top panel so as to prevent any bowing that is in the center.
Then, simply drill the pilot holes if it has not been drilled by the manufacturer itself.
After that, make use of some screws in order to have the bar secured to the panel.
-
Screw the hinges and place the tracks.
The next thing you have to do is to secure the top of each of the hinges on top of the top panel.
Put the wheel axles on the hinges from both sides.
After doing that, you can then install the top as well as the bottom axle supports.
Install the tracks afterward and make sure that the wheels all lie rightfully in the track so as to make sure that it has proper functionality.
Then, attach the cable of the door to the hook that is found on the panel axle support that you can locate at the bottom.
Finally, put the bottom bracket against the wall.
-
Set the springs in place.
This step requires that you assemble the pieces that will support the spring and affix it to the track.
Moreover, use the ceiling from the support of the previous door.
Consequently, rest the section of the track that is curved on the vertical piece that has been made earlier.
Finally, fasten the other rear to the bracket at the ceiling.
-
Reinforce the tracks.
This step will require you to align the horizontal and vertical tracks.
You need to affix these tracks to the door and bolt them together.
-
Link the springs.
In installing a new garage door in Seattle the next step is to link the spring anchors to the springs and affix a locking cone on them.
After that, you need to fasten them securely to the header bracket.
-
Secure the torsion rod and pulleys.
In order to install the torsion rod, simply slide it onto the holes that can be found on the side of the header brackets.
Afterward, just attach the pulleys to both ends of the rod.
Once that is done, attach the cable and then tighten the springs as well.
Keep in mind that you need to employ a garage door installation in Seattle to make sure that it is done safely.
ASAP Garage Doors Seattle
Are you installing a new garage door in Seattle?
ASAP Garage Doors Seattle has got your back.
We are a team of garage door professionals that offer quality garage door repair in Seattle, along with other services on garage door installation in Seattle.
When installing a new garage door in Seattle and looking for an installation company to do it for you, simply contact ASAP Garage Doors Seattle for a guaranteed service.
Do not hesitate to reach out to us for any garage door problems.
Call us now!
