Table of Contents
Garage doors can also have flaws in their operation.
This is due to the fact that some parts of the system may malfunction.
For example, we have the tracks to thank for a seamless operation for whenever the garage door runs on them as they close and open.
They also make sure that the door is balanced well.
However, these tracks can also be out of alignment.
This situation, in return, makes it difficult for the garage door to operate well, given that they may also come out of alignment.
Given that, a garage door track adjustment is needed.
A garage door repair in Seattle can easily provide you with such a service.
But, if you choose to, you can also do it on your own.
However, we recommend that you leave it to the professionals.
For your guide, here are some steps on how to adjust garage door tracks:
Step 1
First, ensure that the garage door is fastened properly in the tracks.
Then, loosen the screws simply by using a screwdriver.
This will make tracks bound in the frame.
Step 2
Using your rubber mallet, tap the end of the track and ensure that it is in a vertical position.
To attain effectiveness, utilize a spirit level to have the perfect alignment of the tracks is verified.
Step 3
Check to see if the track is already in its proper alignment.
After that, simply ensure that the tracks will not be able to move by fastening the screws on it.
Step 4
If you have adjusted the other track, simply move on to the other one.
Simply utilize the rubber mallet and use it at the end of the track.
It should be straightly aligned.
The screws should be tightened afterward.
These steps can help you learn how to adjust garage door tracks without much sweat.
However, keep in mind that if you are not confident, call for a garage door repair in Seattle immediately.
Moreover, the tracks are rubbing on the molding, or else a gap can be seen between the two of them, then you should adhere to the steps below:
Step 5
For this step, all you need to do is to loosen the bolts first.
These bolts secure the tracks to the track bracket by means of a wrench.
Before you move on to the other steps, you have to verify first if the bolts on both tracks have been loosened.
Step 6
For this step, simply place one of the tracks on either side (left or right), until you notice a gap of about ¼ inches between it and the stop molding.
Remember that the gap should be similar.
Perform the step to the other track on the opposite side.
Step 7
Lastly, tighten the track bolts by using a wrench.
Confirm first that they are secured well.
Make sure that they are not overtightened.
Prevent Further Issues
If you have a garage door or garage door tracks that are misaligned, you can bet that it is not an easy issue.
Sometimes, it may not be a matter of misadjustment at all.
On the whole, it might be due to an even bigger issue, which can lead to a whole lot of damage and fixing.
Given that, if you notice your door being out of place, act on it immediately and fix it before it causes any more damage.
It is best to prevent something from happening that have to deal with it in the long run.
It is the same with your garage door.
Once you notice something, you should call a garage door repair in Seattle immediately.
ASAP Garage Doors Seattle
Do you want to know more about how to adjust garage door tracks?
ASAP Garage Doors Seattle has got your back.
We are a team of garage door professionals that offer quality garage door repair in Seattle, along with other services on garage door installation in Seattle.
For how to adjust garage door tracks, simply contact ASAP Garage Doors Seattle for a guaranteed service.
We will adjust your tracks for you!
Do not hesitate to reach out to us for any garage door problems.
Call us now!
