Table of Contents
Adjustments should be made when things are out of place.
Much like your garage door, it should be set in the right direction, balance, and shape so as to ensure proper and smooth movement.
Garage doors run on tracks as it lowers and lifts themselves during operation.
When the track itself is out of adjustment, several problems could occur.
The door could get stuck and refuse to budge, leaving you in a frustrated state with the inconvenience it brings.
However, a garage door track adjustment is entirely possible.
A good garage door repair in Seattle can help you with that.
Or, you can do it on your own.
Here are some steps for your garage door track adjustment:
Safety First!
Trying to adjust the track of the garage door will require you to close the door first.
To do this, just loosen one track at a time.
Bear in mind not to remove the entire lag bolts.
Do loosen the bolts that are fastening the track to the jamb.
After that, slide the bracket up until it has reached the right distance.
More than one of the clips will have to be loosened, and then get the track placed in the right location after you have secured the clips.
Take care to remember that the lag bolts are secured as it attaches the clips to the framing.
Unscrew the tracks.
The first step to a project is to simply remove everything and start over.
This is to make sure that the project goes well without any interference and hassle with the objects that need no fixing.
For the garage tracks, as there are a number of screws fastened around them, we need to loosen them first.
These screws are the ones that are responsible for the fastening of the garage door frame, so they do not unhinge during the operation.
With that in mind, when looking to adjust the tracks, unfastening these screws should be the first step.
Ensure that these screws are unfastened enough before doing anything to adjust the tracks.
Adjust the garage door tracks.
With a garage door track that is out of adjustment, fine-tuning is just what it needs.
First, get a rubber mallet.
This is the tool that we will be used to adjust the tracks.
If you are thinking of swapping it up for a hammer, think again.
A hammer can easily damage the tracks of the garage door, so it should be avoided.
You can then proceed with the adjustment by making use of the mallet.
On the foot of the door track, use the rubber mallet and swing it with force in order to correct the position.
A level tool can also be utilized so as to ensure that the tracks stay in place and in an accurate position.
Fasten the tracks once again.
Once the adjustment and repositioning of the tracks have been done, putting the screws back to where they belong is in the final step.
Tighten the garage door’s screws, and that is basically everything.
For the other tracks, simply repeat the previous steps.
Yet, if you are not sure if you can do a good job in doing such a project, it is best to leave it to the professionals.
A wrong swing of the mallet can cause more damage that can require an even bigger fix.
Given that, as a homeowner, carefully evaluate the risks and your ability to be able to perform such a repair.
Prevent any more problems.
A garage door that is out of alignment or adjustment is not a simple issue.
It is not just a matter of misadjustment.
Once you notice your door being out of place, act on it immediately and fix it before it causes any more damage.
True to that, prevention is the best cure.
The same thing applies to your garage door.
When you notice something is off, have it fixed immediately.
ASAP Garage Doors Seattle
Are you looking for a service for your garage door track adjustment?
ASAP Garage Doors Seattle has got your back.
We are a team of garage door professionals that offer quality garage door repair in Seattle, along with other services on garage door installation in Seattle.
For a garage door track adjustment, simply contact ASAP Garage Doors Seattle for a guaranteed service.
Do not hesitate to reach out to us for any garage door problems.
Call us now!
